During examination of the bullets which were contained within the bodies of the families,there was one bullet from Nicholas which had been described as a "swaged" bullet.
Is anyone familiar with such a bullet as it appears differently " made " from others ? Also,would it fire from the same rifle ? Or is it more an air-rifle product ?
found this :
In internal ballistics, swaging describes the process of the bullet entering the barrel and being squeezed to conform to the rifling. Most firearm bullets are made slightly larger than the inside diameter of the barrel, so that they are swaged to engage the rifling and form a tight seal upon firing. Compare to obturate.
In ammunition manufacture, swaged bullets are bullets manufactured by swaging room temperature metals into a die to form it into the shape of a bullet. The other common manufacturing method is casting, which uses molten metals poured into a mold. Since metals expand when heated and contract when cooled, cast bullets must be cast with a mold slightly larger than the desired finish size, so that as the molten metal cools, it will harden at just the right point to shrink to the desired size. In contrast, swaged bullets, since they are formed at the temperature at which they will be used, can be formed in molds of the exact desired size. This means that swaged bullets are generally more precise than cast bullets. The swaging process also leads to fewer imperfections, since voids commonly found in casting would be pressed out in the swaging process. The swaging process in reference to cold flow of metals into bullets is the process not of squeezing the metals into smaller forms but rather pressing smaller thinner items to form into shorter and slightly wider shapes.
Individuals who make their own bullets usually are not aware of available manual specialized equipment and dies required for swaging bullets, and thus choose to make cast bullets. To get high precision results, it is common to cast the bullets slightly oversized, then swage the resulting castings through a die to do the final forming. Since the amount of pressure required to size the bullet is far less than that required to form a bullet, a simple mechanical press can be used, often the same press used for handloading ammunition.
